LW2 V6-3.0L VIN R (2000)
8.
Remove old adhesive tape from back of roof ditch molding and apply KENT Industries High Strength Side Molding tape (P/N 40519) or
equivalent.
9.
Center roof ditch molding in opening and install onto vehicle.
10.
Install C-Pillar Trim (Sedan) or Quarter Glass Side Molding (Wagon).
^
On Sedan Models, install C-Pillar Trim, refer to "C-Pillar Trim" installation procedure in the Interior Trim section of the 2000 - 2001 or 2002
L-Series Body/Electrical Volume II Service Manual.
^
On Wagon Models, install Quarter Glass Side Molding, refer to "Quarter Glass Side Molding" installation procedure in the Interior Trim
section of the 2000 - 2001 or 2002 L-Series Body/Electrical Volume II Service Manual.
REAR COMPARTMENT - DRAIN GUTTER SEAMS (SEDAN ONLY)
1.
Apply a soapy water solution to the front weld seam in the rear compartment drain gutter.
2.
Apply air pressure with an air hose at the underside of the seam. Do not exceed 205 kPa (30 psi).
Note:
Right side shown, left side similar.
3.
Observe for bubbles on the exterior surface of the seam at the suspected leak area.
4.
Seal the areas using KENT Industries High Tech Clear seam sealer (P/N 10200) or equivalent, allow time to cure.
5.
Retest the seam using a water test stand. Set at 155 kPa (22 psi) water pressure.
6.
Inspect for water entry from inside the rear compartment.
7.
Install rear compartment trim.
REAR COMPARTMENT - REAR WINDOW
BONDING FLANGE VOID IN URETHANE
BEAD (SEDAN ONLY)
1.
With rear compartment lid open use a garden hose with an unrestricted (no nozzle) flow of water, direct water flow at lower corners of rear
window lace.
2.
Inspect for water entry in the rear compartment, at the rear shelf panel.
