LW2 V6-3.0L VIN R (2000)
7. If the master cylinder is suspected of having air in its bore, it must be bled before proceeding to brake line bleeding.
a. Loosen front brake pipe at master cylinder.
b. Allow brake fluid to flow from front master cylinder port until all air is removed from front master cylinder bore.
c. Tighten front brake pipe into master cylinder.
Torque: 16 Nm (12 ft. lbs.)
d. Loosen rear brake pipe (rear port) at master cylinder.
e. Allow brake fluid to flow from rear master cylinder port until all air is removed from rear master cylinder bore.
f.
Tighten rear brake pipe into master cylinder.
Torque: 16 Nm (12 ft. lbs.)
8. Bleed individual calipers and wheel cylinders.
IMPORTANT: To assist in freeing entrapped air, tap lightly on caliper casting with a rubber mallet.
a. Place wrench over bleeder screw.
b. Attach transparent hose over bleeder screw nipple. Submerge other end of hose in a transparent container of brake fluid.
c. Loosen bleeder screw, allow fluid to flow into container until all air is removed.
d. Tighten bleeder screw.
