LW2 V6-3.0L VIN R (2000)
6. Remove rotor retaining screw.
7. Remove rotor from vehicle.
THICKNESS CHART
New 25 mm (0.984 inch)
Minimum after Turning 23 mm (0.905 inch)
Discard 22 mm (0.866 inch)
IMPORTANT: Refer to "Inspecting and Refinishing Brake Rotors".
INSTALLATION
1. Install brake rotor onto wheel hub.
2. Tighten rotor retaining screw.
Torque: 4 Nm (35 inch lbs.)
NOTICE: Clean caliper support bracket fasteners thoroughly with brake and choke cleaner (P/N 21007432 or equivalent). Apply thread locker
Loctite(R) 272 (or equivalent) to caliper support bracket fasteners. If Loctite(R) 272 (or equivalent) is not available, new caliper support bracket
fasteners must be used.
