LW2 V6-3.0L VIN R (2000)
3. Install caliper bracket-to-steering knuckle bolts.
Torque: 95 Nm (70 ft. lbs.)
4. Attach brake pressure hose and install locking plate.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel bolts to loosen in service.
5. Install front wheel and tire assemblies.
6. Install wheel bolts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
Torque: 125 Nm (92 ft. lbs.)
7. Lower vehicle from hoist.
Rear Brake Rotor
WHEN INSTALLING NEW BRAKE ROTORS, DO NOT REFINISH THE SURFACES AS THESE PARTS ARE AT THE CORRECT LEVEL OF
SURFACE FINISH.
REMOVAL
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST.
