LW2 V6-3.0L VIN R (2000)
4. Install brake pipe bracket to rear axle control arm.
Torque: 8 Nm (71 inch lbs.)
5. Install brake pads.
6. Bleed brakes.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel nuts to loosen in service.
7. Position wheel and tire assembly onto hub.
8. Install wheel bolts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
Torque: 125 Nm (92 ft. lbs.)
9. Lower vehicle from hoist.
