LW2 V6-3.0L VIN R (2000)
1. Using a small screw driver, carefully pry piston boot clamp ring from boot.
2. Remove piston boot.
CAUTION: TO PREVENT BODILY INJURY, MAKE SURE TO KEEP FINGERS OR OTHER BODY PARTS AWAY FROM
PISTON DURING REMOVAL.
NOTICE: Pad interior of caliper body to provide a protective cushion for piston when it exits the caliper. This will protect piston from surface
damage caused from piston/caliper body contact.
3. Block opposite piston with holding tool KM-286 and carefully remove piston from caliper by applying low pressure, non-lubricated, compressed
air into caliper inlet hole.
4. Remove piston seal from groove of caliper.
