LW2 V6-3.0L VIN R (2000)
5. Remove control unit mounting nuts and bracket.
NOTICE: Be careful not to excessively bend brake pipes.
6. Remove ABS control assembly from vehicle.
DISASSEMBLY
IMPORTANT: Do not attempt to repair damaged solenoid pack or control unit assemblies. Repair of these assemblies is not possible. Do not
lubricate or oil ABS control assembly.
1. Disconnect pump motor electrical connector.
2. Remove ABS control module to hydraulic control unit screws.
3. Separate ABS control module from hydraulic control unit.
ASSEMBLY
1. Position ABS control module on hydraulic control unit.
2. Install attaching screws.
3. Connect pump motor electrical connector.
INSTALLATION
