LW2 V6-3.0L VIN R (2000)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
^
TOOLS REQUIRED
-
SA9140E Torque Angle Gauge
REMOVAL
The rear wheel speed sensor is contained within the hub/bearing assembly. The sensor is not serviceable separately. To replace a damaged rear wheel
speed sensor, the entire hub/bearing assembly must be replaced.
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST.
1. Raise vehicle on hoist.
2. Remove rear wheel and tire assembly corresponding to hub being replaced.
3. Disconnect electrical connector from ABS wheel speed sensor.
4. Vehicles equipped with rear disc brakes, perform the following:
a. Remove brake pipe to control arm support bracket.
b. Remove caliper-to-knuckle fasteners.
c. Remove caliper, hang from strut spring with mechanic's wire.