LW2 V6-3.0L VIN R (2000)
Brake Switch (Cruise Control): Service and Repair
Cruise Brake Switch
REMOVAL
1. Remove left lower I/P closeout panel (hush panel) push pins and remove.
2. Disconnect electrical connector.
3. Remove switch by rotating 180 degrees and then pull it out of the bracket.
INSTALLATION
1. Install switch into bracket and rotate 180 degrees.
2. Connect electrical connector.
3. Adjust cruise brake switch.
a. Depress brake pedal.
b. Pull-out plunger on brake switch.
c. Lift-up on brake pedal.
4. Install left lower I/P closeout panel (hush panel).
