LW2 V6-3.0L VIN R (2000)
Brake Switch (Cruise Control): Technical Service Bulletins
Electrical - Stop Lamp/Cruise Switch Procedure Revision
BULLETIN NO.: 00-T-62
ISSUE DATE: November, 2000
CATEGORY TYPE: Engine - 18
CATEGORY: Cruise Control
CORPORATION NO.: 00-08-68-002
SUBJECT:
Revised Service Procedure Regarding Stop Lamp switch and Cruise Brake Switch Adjustment
MODELS AFFECTED:
2000 - 2001 Saturn L-Series Vehicles
PURPOSE:
The purpose of this bulletin is to provide an updated service procedure for Stop Lamp Switch and Cruise Brake Switch Adjustment.
The following service procedure affects the current adjustment procedure in the following service manuals:
^
2000/2001 L-Series Brakes Service Manual
^
2000 L-Series (L61) Engine Service Manual
^
2001 L-Series (L61) Engine Service Manual
^
2000 L-Series (L81) Engine Service Manual
^
2001 L-Series (L81) Engine Service Manual
IMPORTANT
It is important when adjusting the Stop Lamp Switch or Cruise Brake Switch to use only the procedure outlined in this bulletin. Disregard all other
adjustment procedures.
STOP LAMP/CRUISE BRAKE SWITCH ADJUSTMENT
1.
Turn ignition to the OFF position.
2.
Remove left side lower I/P closeout panel (hush panel) push pin fastener and remove duct.
3.
Remove left side lower heater duct assembly push pin fastener and remove duct.
