LW2 V6-3.0L VIN R (2000)
5.
Remove heater core inlet hose from heater core pipe by depressing quick connect collar tab, located at 6 o'clock, and pulling black collar toward
front of vehicle and then pulling quick connect off of heater core pipe.
6.
Disconnect heater inlet hose from the heater water pump.
7.
Disconnect electrical connector from heater water pump.
8.
Remove heater water pump mount and heat shield-to-bracket bolt (E10 Torx(R) socket required) and remove mount and shield.
9.
Discard pump, shield, and inlet hose, but save the clamps and bolt to attach the pump to the engine (they will be reused).