LW2 V6-3.0L VIN R (2000)
Crankshaft Main Bearing Seal: Service and Repair
-
Tool Required
-
J-42067 Rear Main Oil Sealer Installer
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the flexplate.
3. Center punch the steel ring of the rear main oil seal.
4. Carefully drill a small, shallow pilot hole into steel ring of the rear main oil seal. Use caution when drilling the hole so as not to damage the engine
components on the opposite side of the rear main oil seal.
5. Screw in a self-tapping screw.
6. Use pliers to pull out rear main oil seal.
7. Clean all sealing surfaces.
INSTALLATION
