LW2 V6-3.0L VIN R (2000)
Important:
Timing marks on timing belt are used for initial installation only.
33.
Tighten lever arm to the water pump pulley flange.
34.
Inspect 3-4 timing marks for alignment and realign if necessary.
35.
Remove J 42069-20 checking gauge from 3-4 camshaft sprockets and install on 1-2 camshaft sprockets.
36.
Install J 42069-2 green camshaft locking tool onto 3-4 camshafts.
37.
Adjust upper idler pulley by rotating counterclockwise until the 1-2 timing marks on the sprockets are lined up with marks on J 42069-20 checking
gauge.
38.
Tighten idler pulley, using J 42069-40 alignment tool to hold pulley while tightening fastener.
Tighten
Tighten the idler pulley fastener to 20 Nm (15 lb ft).
