LW2 V6-3.0L VIN R (2000)
Important:
Ensure that the 3-4 timing marks are about 1 mm (approximately the width of the timing marks on the sprockets) on the retard side. If they are
not, turn lower idler clockwise to allow retard of the 3-4 cams and repeat previous step.
26.
Remove crankshaft locking tool J 42069-10.
Important:
If TDC is passed, do not rotate crankshaft counterclockwise. This will not allow proper slack to be taken up between timing belt tensioner and
crankshaft sprocket. To correct, rotate crankshaft additional two turns.
27.
Rotate crankshaft 1-3/4 turns clockwise. Install J 42069-10 and then stop at TDC.
28.
Tighten lever arm to the water pump pulley flange.
