LW2 V6-3.0L VIN R (2000)
7. Lower vehicle from hoist.
NOTICE: Always use a nickel-based anti-seized compound (Saturn P/N 21485279 or equivalent) on the threads of the oxygen sensor. If the oxygen
sensor is replaced, do not apply anti-seize to the new sensor. New sensors have anti-seize pre-applied. Never use silicon product; silicon products will
cause damage to oxygen sensor.
8. Install oxygen sensor.
^
Torque: 45 Nm (33 ft. lbs.)
9. Connect oxygen sensor harness connector.
10. Install exhaust manifold pipe heat shield.
^
Torque: 8 Nm (71 inch lbs.)
11. Start engine and check for exhaust leaks.
