LW2 V6-3.0L VIN R (2000)
1. Push connector duct adapters completely up onto main duct.
2. Install connector duct onto HVAC module.
3. Install connector duct to HVAC module screw.
Torque: 1 N.m (9 in-lbs)
4. Pull both legs of connector duct down to seal against the left and right rear seat heater ducts.
5. Install I/P bracket.
Torque: 20 N.m (15 ft-lbs)
6. Position console into vehicle. Route shifter/PRNDL boot through console opening.
7. Install console front fasteners.
Torque: 2.5 N.m (22 in-lbs)
8. Move front seats forward and install console rear fasteners.
