LW2 V6-3.0L VIN R (2000)
Caution:
Do not use match or open flame to apply heat to seal. Use of a match or open flame may cause scorching or worse, the seal could start to
combust or burn.
22.
Apply heat using the heat gun or some other device. Heat to 175°C (347°F) until glue flows around edges of sleeve.
23.
While the sleeve is still hot, use a pair of pliers and pinch the open end of the sleeve together. Hold together for about 10 seconds.
24.
Repeat steps 18-21 for the second wire.
25.
Tape wires together and install into conduit.
26.
Wrap end of conduit with electrical tape.
27.
Install the radiator upper mount brackets.