LW2 V6-3.0L VIN R (2000)
NOTE: Do not remove pulley without puller adapter. If A/C compressor shaft is pressed on, A/C compressor will be damaged.
5. Position the puller center tool SA9149AC-2 on end of A/C compressor shaft.
IMPORTANT: Make sure to hook the puller jaw behind the pulley only, not the coil.
6. Install three-jaw puller on A/C compressor pulley. Tighten center bolt to remove pulley assembly.
IMPORTANT: To enable easier removal of screws, lightly tap on the end of the screwdriver with a plastic hammer.
7. Remove A/C compressor clutch coil screws and remove A/C compressor clutch coil.
INSTALLATION
1. Position A/C compressor clutch coil so that electrical connector is aligned with indent in compressor front head.
2. Install A/C compressor clutch coil screws.
