LW2 V6-3.0L VIN R (2000)
19. Remove receiver/dehydrator line fitting bolts.
20. Loosen receiver/dehydrator clamp bolt and remove receiver/dehydrator.
INSTALLATION
1. Add any compressor oil that was removed during discharge to receiver/dehydrator bottle.
2. Add appropriate amount of compressor oil to system for parts replaced. (See Oil Distribution.)
3. Install receiver/dehydrator bottle into clamp but do not tighten.
NOTE: Use only mineral oil to lubricate O-rings. Use of PAG oil will cause premature corrosion of joint.
IMPORTANT: Always install new O-rings.
