LW2 V6-3.0L VIN R (2000)
TO AVOID CUTTING INTERNAL COMPONENTS, CUT ONLY INSIDE THE RAISED BEAD AREA.
NOTICE:
Do not cut through or damage raised bead, this bead will be used as a sealing surface when completing procedure.
16.
Using a sharp utility knife cut through module wall, following inside of raised bead as a guide. Several passes may be necessary to do this.
NOTICE:
Use care when cleaning and removing debris around the evaporator as not to damage the fins.
17.
Carefully clean out any moisture or debris that may be inside the module.
18.
Put on rubber gloves, safety glasses, and NIOSH approved acid gas/organic vapor respirator.
19.
Using cleaning gun, OTC Tool SA9216NE (or equivalent siphon-type parts cleaning spray gun capable of delivering 2 ounces per minute of liquid
with shop air at 552-620 kPa [80-90 psi]), insert siphon hose into container of cooling coil coating. Take care to place the bottle in a secure upright
position to avoid spilling contents.
20.
Regulate shop air to 276-414 kpa (40-60 psi).
21.
Insert nozzle tip of spray gun so spray pattern will be parallel to the evaporator face.
22.
Apply cooling coil coating using short bursts and rotating the nozzle tip up and down. This will allow for an even distribution and to ensure full
coverage of the evaporator.
NOTICE:
Proper sealing is important to prevent condensation from leaking into the passenger compartment.
