LW2 V6-3.0L VIN R (2000)
PROVIDE ADDITIONAL SUPPORT TO OPPOSITE END OF VEHICLE THAT COMPONENTS ARE REMOVED FROM.
2.
Raise vehicle on a hoist.
3.
Check the HVAC module drain for blockage. If necessary, clear drain hole with a soft blunt tool such as the eraser end of a pencil.
4.
Lower vehicle from hoist.
5.
Place a drain pan directly below the HVAC drain to collect disinfectant or cooling coil coating and rinse water runoff.
6.
Open all doors and windows in the vehicle.
7.
Position pedestat fan so that it provides cross ventilation through the vehicle during the cleaning/coating procedure.
8.
Cover interior of vehicle with suitable protective coverings to protect surfaces from overspray.
CAUTION:
THE FOLLOWING PROCEDURE SHOULD ONLY BE PERFORMED ON A COLD VEHICLE. IT HAS BEEN DEMONSTRATED THAT
IRRITATING VAPORS WILL BE FORMED IN THE ENGINE COMPARTMENT IF THE COOLING COIL COATING COMING OUT OF
THE DRAIN OUTLET CONTACTS HOT ENGINE COMPONENTS. COOLING COIL COATING CAN CAUSE SUBSTANTIAL, BUT
TEMPORARY EYE INJURY. DO NOT GET COOLING COIL COATING IN EYES OR ON CLOTHING. WASH THOROUGHLY WITH SOAP
AND WATER AFTER HANDLING.
FIRST AID:
IF COOLING COIL COATING GETS INTO EYES, HOLD EYELIDS OPEN AND FLUSH WITH A STEADY, GENTLE STREAM OF WATER
FOR 15 MINUTES. OBTAIN MEDICAL ATTENTION IF IRRITATION PERSISTS.
9.
Allow vehicle to cool down before performing cooling coil coating procedure.
10.
Remove right side console extension.
