LW2 V6-3.0L VIN R (2000)
27.
Install right side I/P lower dash insulator and retainers.
28.
Install right side console extension.
29.
Allow evaporator core to soak for 15 minutes.
IMPORTANT:
The 5 minute drying time is an important step in curing the cooling coil coating to the evaporator.
30.
Dry evaporator by:
^
Adjusting temperature to full hot
^
Adjusting mode to heater only
^
Turning RECIRC On
^
Making sure A/C button is Off Open windows 1/2 in. and close doors
^
Start engine and allow to reach operating temperature
^
Allow blower motor to operate on HI blower for 5 minutes once engine reaches operating temperature.
31.
Properly dispose of cooling coil coating runoff collected in drain pan into a approved container.
32.
Remove protective coverings from interior of vehicle.
33.
Remove pedestal fan from area.
