LW2 V6-3.0L VIN R (2000)
^
When applying cooling coil coating (P/N 12346390), National Institute of Occupational Safety and Health (NIOSH) approved acid gas/organic
vapor respirator with chlorine dioxide cartridges (3M(R) P/N 5103-small, 5203-medium, 5303-large), which are to be used with a pre-filter (P/N
5010) and retainer (P/N 501), or equivalents.
^
Rubber gloves
^
Pedestal fan
1.
Dry evaporator by:
^
Adjusting temperature to full hot
^
Adjusting mode to heater only
^
Turning RECIRC On
^
Making sure A/C button is Off
^
Close all doors and windows
^
Start engine and allow to reach operating temperature
^
Once engine reaches operating temperature, allow blower motor to operate on HI blower for 5 minutes.
CAUTION:
MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID PERSONAL INJURY,
PROVIDE ADDITIONAL SUPPORT TO OPPOSITE END OF VEHICLE THAT COMPONENTS ARE REMOVED FROM.
2.
Raise vehicle on a hoist.
3.
Check the HVAC module drain for blockage. If necessary, clear drain hole with a soft blunt tool such as the eraser end of a pencil.
4.
Lower vehicle from hoist.
5.
Place a drain pan directly below the HVAC drain to collect disinfectant or cooling coil coating and rinse water runoff.
6.
Open all doors and windows in the vehicle and position pedestal fan so that it provides cross ventilation through the vehicle during the
cleaning/coating procedure.
7.
Cover interior of vehicle with suitable protective coverings to protect surfaces from overspray.
CAUTION:
THE FOLLOWING PROCEDURE SHOULD ONLY BE PERFORMED ON A COLD VEHICLE. IT HAS BEEN DEMONSTRATED THAT
IRRITATING VAPORS WILL BE FORMED IN THE ENGINE COMPARTMENT IF THE COOLING COIL COATING COMING OUT OF
