LW2 V6-3.0L VIN R (2000)
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System as shown.
IMPORTANT:
When it is necessary to clean and disinfect the HVAC system at the same time the delayed blower motor control module package is installed, submit
labor operation D33 9 as a "related line" to failed labor operation D3316.
DISCLAIMER
Cleaning and Cooling Coil Coating Application
Before starting procedure, obtain the following equipment and supplies:
^
A/C System Cooling Coil Coating (P/N 12346390)
^
Cleaning Gun, OTC Tool SA9216NE
CAUTION:
WHEN APPLYING COOLING COIL COATING (P/N 12346390), ORDINARY SAFETY GLASSES ARE NOT SUFFICIENT.
^
Safety goggles
^
When applying cooling coil coating (P/N 12346390), National Institute of Occupational Safety and Health (NIOSH) approved acid gas/organic
vapor respirator with chlorine dioxide cartridges (3M(R) P/N 5103-small, 5203-medium, 5303-large), which are to be used with a pre-filter (P/N
5010) and retainer (P/N 501), or equivalents.
^
Rubber gloves
^
Pedestal fan
1.
Dry evaporator by:
^
Adjusting temperature to full hot
^
Adjusting mode to heater only
^
Turning RECIRC On
^
Making sure A/C button is Off
^
Close all doors and windows
^
Start engine and allow to reach operating temperature
^
Once engine reaches operating temperature, allow blower motor to operate on HI blower for 5 minutes.
CAUTION:
MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID PERSONAL INJURY,
