LW2 V6-3.0L VIN R (2000)
16. While gently lifting evaporator pipes and block with one hand, gently press TXV inward until fully installed onto both pipes. When completely
installed, TXV should be almost flush with edge of bevel of TXV foam seal.
17. Remove suction/liquid line assembly to TXV bolt from TXV
NOTE: Improper installation of TXV to evaporator pipes will damage pipes requiring evaporator core replacement.
18. Thread TXV to evaporator core block bolts into block by hand. Bolts should thread in easily. Do not force! If bolts do not thread in easily, verify
that TXV is properly installed onto both pipes and fully seated to block.
19. After verifying proper installation, tighten both TXV to block bolts.
Torque: 7 N.m (62 in-lbs)
20. Thoroughly clean the O-ring surfaces of the TXV
21. Install new O-rings to suction/liquid line assembly block.
22. Lubricate the O-rings with clean mineral oil.
23. Install suction/liquid line assembly block to TXV
24. Install suction/liquid line assembly to TXV bolt.
Torque: 7 N.m (62 in-lbs)
