LW2 V6-3.0L VIN R (2000)
18.
Tape wires together and install into conduit.
19.
Wrap end of conduit with electrical tape.
20.
Install conduit into attachment clips.
21.
Install heater inlet hose to the heater inlet elbow. Orient the elbow so that the elbow bracket will attach to the heater pump bracket on the engine.
Use saved clamps to secure hoses to the elbow.
22.
Using the saved attachment bolt, secure the elbow and hose assembly to the engine at the heater pump mounting bracket.
Torque:
Heater Inlet Elbow Bolt: 8 N.m (71 in-lbs)
23.
Install heater core inlet quick connect to heater inlet pipe (closest to driver's side). Holding quick connect by black collar, slide onto heater core
pipe. When quick connect engages heater core pipe bead, collar will slide toward front of dash and lock into position. A green paint band will be
visible when collar is properly positioned.
24.
Verify proper engagement of quick connect by attempting to pull hose off heater pipe.
25.
With hoses properly positioned, close heater hose assembly to manifold clamp.
