LW2 V6-3.0L VIN R (2000)
h. Repeat sequence until all air is removed from front (secondary) master cylinder bore.
i.
Loosen rear brake pipe (rear port) at master cylinder.
j.
Allow brake fluid to flow from rear master cylinder port.
k. Tighten rear brake pipe into master cylinder.
Torque: 16 Nm (12 ft. lbs.)
l.
Loosen rear brake pipe at master cylinder 1/4 turn.
m. Depress brake pedal slowly until fluid is seen coming from pipe fitting.
n. Once again, tighten rear brake pipe into master cylinder while pedal is being depressed.
Torque: 16 Nm (12 ft. lbs.)
o. Slowly release pedal.
p. Repeat sequence until all air is removed from rear (primary) master cylinder bore.
3. Bleed individual calipers and wheel cylinders.
IMPORTANT: To assist in freeing entrapped air, tap lightly on caliper casting with a rubber mallet.
a. Place wrench over bleeder screw.
b. Attach transparent hose over bleeder screw nipple. Submerge other end of hose in a transparent container of brake fluid.
c. Loosen bleeder screw.
d. Apply brake pedal slowly and hold.
e. Tighten bleeder screw.
Torque: 8 Nm (71 inch lbs.)
f.
Release brake pedal.
g. Repeat sequence until all air is removed from brake pipes.
