LW2 V6-3.0L VIN R (2000)
6. Raise vehicle.
7. Remove suction pipe to suction line assembly nut.
8. Remove suction pipe and seal washer from suction/liquid line assembly.
9. Install cap on suction line assembly hose to prevent moisture entry and oil spillage.
10. Lower vehicle.
INSTALLATION
1. Remove compressor suction port cap and add any PAG oil that was removed during refrigerant recovery.
NOTE: Do not lubricate seal washers.
IMPORTANT: Always install new seal washers.
2. Remove suction pipe cap and install new seal washer.
3. Install suction pipe to compressor and hand start bolt.
Torque: 40 N.m (30 ft-lbs)
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL
INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END
FROM WHICH COMPONENTS ARE BEING REMOVED.
