LW2 V6-3.0L VIN R (2000)
Right Splash Shield-to-Body
Bolts: 5 Nm (44 in-lbs)
7.
Lower vehicle.
8.
Connect negative battery cable.
Torque:
Battery Terminal Bolt: 17 Nm (13 ft-lbs)
IMPORTANT:
Do not cover any existing underhood labels when affixing Campaign Completion Label.
9.
Affix Campaign Completion Label on a clean and dry surface of radiator core support, in an area clearly visible when hood is raised. (For more
information, refer to "Campaign Completion Label" in this bulletin.)
L61
1.
Disconnect negative battery cable.
IMPORTANT:
Verifying the purity of the refrigerant with a purity identifier before recovery is recommended.
2.
Recover refrigerant using an approved refrigerant recovery system. Measure the amount of oil removed during recovery and record.
CAUTION:
DO NOT REMOVE HOSES OR LINES BEFORE SYSTEM IS FULLY DISCHARGED.
3.
Remove suction pipe-to-compressor bolt.
4.
Remove suction pipe and seal washer from compressor.
NOTICE:
Do not lubricate seal washers.
5.
Install new seal washer and new bolt on suction pipe.
6.
Install suction pipe-to-compressor and hand start bolt.
Torque:
Suction Pipe-to-Compressor
Bolt: 19 Nm (14 ft-lbs)
7.
Remove discharge line and seal washer from compressor.
