LW2 V6-3.0L VIN R (2000)
23.
Install right front lower splash shield bolts.
Torque:
Right Splash Shield-to-Body
Bolts: 5 Nm (44 in-lbs)
24.
Lower vehicle.
25.
Connect oxygen sensor connector and route wiring into clips.
26.
Install battery heat shield.
27.
Connect negative battery cable.
Torque:
Battery Terminal Bolt: 17 Nm (13 ft-lbs)
28.
Evacuate, recharge, and leak check the A/C system.
IMPORTANT:
Do not cover any existing underhood labels when affixing Campaign Completion Label.
29.
Affix Campaign Completion Label on a clean and dry surface of radiator core support, in an area clearly visible when hood is raised. (For more
information, refer to "Campaign Completion Label" in this bulletin.)
