LW2 V6-3.0L VIN R (2000)
Timing Belt: Service and Repair
Timing Belt Replacement (In-Vehicle)
Timing Belt Replacement
Tools Required:
J42069 Timing Belt Alignment Kit
J42098 Crank Hub TORX Socket
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the timing belt front cover.
3. Rotate the crankshaft using the J42098 until the #1 cylinder is at 60 degrees before top dead center (BTDC).
4. Install the crankshaft locking tool J42069.
5. Rotate the crankshaft in the engine rotational direction (clockwise) using the J42098 until #1 cylinder is at TDC and tighten the lever arm to the
water pump pulley flange.
Important: Ensure that the alignment of the crankshaft is not 180 degrees off. The alignment marks must align with the corresponding notches on the
rear timing belt cover.
6. Install 1-2 and 3-4 camshaft locks, J42069 and J42069-2.
