LW2 V6-3.0L VIN R (2000)
Fuse Block: Service and Repair
Underhood Fuse Block
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the positive battery cable.
IMPORTANT: It is not necessary to disconnect fan control module wiring from module. Additional wiring has been included in harness for
diagnosis and service.
3. Remove the fan control module by sliding up and off of bracket. Leaving wiring connected, lay fan control module out of the way.
4. Remove battery hold down/fan control module bracket bolt and bracket.
5. Remove battery.
6. Uncover battery feed on the fuse block cover.
7. Disconnect battery feed to the fuse block.
8. Unsnap the engine cooling hose from the fuse block cover.
9. Push on tabs at the end of the fuse block and lift off cover (2).
10. Push in tabs (3) on the end of the fuse block case and roll back the fuse block (1).
11. Remove connectors.
(1) Engine 68 Way
(2) Forward Lamp 68-Way
(3) I/P 68-Way
(4) Forward Lamp 2-Way (White)
(5) I/P 2-Way (Black)
(6) I/P 2-Way (Green)
(7) I/P 2-Way (Brown)
12. Lift fuse block off the case.
