LW2 V6-3.0L VIN R (2000)
Engine Control Module: Reading and Clearing Diagnostic Trouble Codes
Accessing and Reading Diagnostic Trouble Codes
The provision for communicating with the PCM is the Data Link Connector (DLC). It is located under the instrument panel. It is used in the assembly
plant to receive information in checking that the engine is operating properly before it leaves the plant.
The diagnostic trouble code(s) stored in the PCM's memory can be read only through a hand-held diagnostic Scan tool plugged in the DLC connector
when the ignition is turned On.
Clearing Diagnostic Trouble Codes
Clearing diagnostic trouble codes is accomplished by choosing the "Clearing Trouble Codes" option in the Scan tool DTC menu. Disconnecting the
battery for 60 seconds (may be longer in some cases) will clear DTCs from the ECM's memory. Failure records will also be cleared.