LW2 V6-3.0L VIN R (2000)
9. Tighten hose clamp on filler pipe to fuel tank connecting hose.
Torque: 4 N.m (35 in-lbs)
10. Connect EVAP canister vent pipe at quick connect to canister vent hose.
11. Tighten lower attachment screw on filler pipe to underbody.
Torque: 13 N.m (9.5 ft-lbs)
12. Connect the wiring harness to EVAP vent solenoid.
13. Install wheelhouse inner liner to wheel opening.
14. Perform "Service Bay Diagnostic Test" for evaporative emission system using Scan tool. This test will verify integrity of vapor handling areas of
fuel system.
