LW2 V6-3.0L VIN R (2000)
17.
Install intake plenum bolts.
Tighten
Tighten the Intake Plenum Bolts to 8 N.m (71 in-lbs).
18.
Connect hose clamps from intake plenum-to-runner rubber boots using universal clamp pliers tool J-43914. If clamps are damaged, replace with
service screw type clamps.
19.
Install air cleaner inlet hose.
20.
Remove tape and conduit 228.6 mm (9 in) from throttle body connector.
Notice:
Damaged or broken throttle body connector retainer clips may result with intermittent electrical connection and (MIL) Service Engine Soon Telltale
Lamp or Reduced Power Lamp illuminating.
