LW2 V6-3.0L VIN R (2000)
Ignition Control Module: Service and Repair
Ignition Module/Passlock Sensor
IMPORTANT: Passlock sensor is part of ignition module.
REMOVAL
1. Disable the SIR system.
2. Remove lock cylinder bezel from steering column shroud by carefully prying with a thin bladed screwdriver.
3. Remove steering column upper shroud panel.
4. Insert key into ignition lock cylinder and rotate to START position. Then rotate cylinder back to the RUN position.
5. Depress the locking button on the top of ignition module assembly with a thin pick-type tool. Slide lock cylinder assembly from ignition module.