LW2 V6-3.0L VIN R (2000)
15.
If ignition housing did not require replacement, depress the locking button on the top of ignition module assembly with a thin pick-type tool. Slide
lock cylinder assembly from ignition module.
16.
Discard old lock cylinder assembly. New lock cylinder and components must be used. Refer to PARTS REQUIREMENTS section in this bulletin
for specific parts requirements.
IMPORTANT:
New lock cylinder must be coded. Follow steps 17 through 22 for coding procedure.
IMPORTANT:
Ignition lock cylinder reads key cut positions 2 through 10.
17.
Replace ignition cylinder, ignition cylinder tumblers, and tumbler springs.
