LW2 V6-3.0L VIN R (2000)
20.4. Stake retainer plate with punch at locations shown in illustration.
21.
To check coding of cylinder, insert key. If coding is correct, side-bar will be flush with cylinder with key inserted.
22.
For assembly, oil lock set with a light oil or graphite lubricant.
IMPORTANT:
Actuator blade within ignition module housing must be in the RUN position to install lock cylinder assembly. If rotated, replace it to the RUN
position using needle nose pliers.
23.
Insert ignition key into ignition lock cylinder and install into ignition housing.
