LW2 V6-3.0L VIN R (2000)
31.
If ignition module/passlock sensor did not require replacement, depress the locking button on the top of ignition module assembly with a thin
pick-type tool. Slide lock cylinder assembly from ignition module.
32.
Discard old lock cylinder assembly. New lock cylinder and components must be used. Refer to PARTS REQUIREMENTS section in this bulletin
for specific parts information.
IMPORTANT:
New lock cylinder must be coded. Follow steps 32 through 37 for coding procedure.
IMPORTANT:
Ignition lock cylinder reads key cut positions 2 through 10.
33.
Replace ignition cylinder, ignition cylinder tumblers. and tumbler springs.
