LW2 V6-3.0L VIN R (2000)
Important:
Make sure the intermediate shaft is being pressed over the ears of the solid shaft.
7.
Use a hard surface to ease the collapse of the intermediate shaft. It is best to use a pumping action when collapsing the shaft. Collapse the shaft as
far as possible.
8.
Slowly extend and collapse the slip joint fully. Repeat 15 times to distribute the grease.
9.
Slowly extend the intermediate shaft apart.
10.
Inspect the intermediate shaft for a minimum of 5 mm (0.2 in) (a) of grease past the shaft splines.
11.
Repeat steps 4-9 if less than 5 mm (0.2 in) of grease is past the shaft splines.
12.
Remove the rubber stopper plug from the yoke end of the shaft.
Important:
Before installing the intermediate shaft, make sure to compress and extend the intermediate shaft at least 15 times to completely lubricate the
internal surface of the slip joint.
13.
Reinstall the intermediate shaft into the vehicle. Refer to the "Intermediate Steering Shaft Replacement" procedure in the appropriate Saturn
L-Series Service Manual or SI.
