LW2 V6-3.0L VIN R (2000)
Electronic Brake Control Module: Diagram Information and Instructions
Harness Connector Faces
Wire Sizes
This wiring section contains the harness connector faces for all of the connectors used in the vehicle. These views can be used to show what the
connector looks like and where a particular terminal in the connector is located. The connectors are labeled using the name of the component they are
connected to, as well as the color of the connector and the connector number. Beside each connector is a chart that lists the connector cavities, wire
color, wire size, circuit number, and circuit function. Under each chart is the location of the connector, the color of the connector test probe that goes to
that connector, and the Packard part number/Saturn Special Tool Catalog part number of the tool to use to remove the terminal in that connector.
Power Distribution
Power Distribution contains schematics that show the wiring from the Battery and Generator to the Starter Solenoid, Fuse Block, and Ignition Switch.
Fuse Block Details
Fuse Block Details contains schematics that show all of the wiring between a fuse and the components connected to that fuse. The Fuse Block Details
can be very helpful in locating a short circuit that caused a fuse to open.
Ground Distribution
Ground Distribution contains schematics and locations of all grounds on the vehicle. This information can be a time-saver when troubleshooting a
ground circuit problem.
Service Parts Identification Label
To aid service and parts personnel in identifying options and parts originally installed, a Service Parts Identification Label has been placed in the vehicle.
Refer to the Specifications Quick Reference Manual for the location of the label and the definition of the option codes.
