LW2 V6-3.0L VIN R (2000)
IMPORTANT:
Right mounting bracket shown. Left mounting bracket similar.
IMPORTANT:
There is an oval hole in passenger inflator module mounting bracket. The measurements taken in the following steps should be performed on the
inside edges of module mounting bracket and centered with oval hole in bracket.
21.
Measure passenger inflator module right mounting bracket slot on I/P cross-car beam at location (A).
(A) 19 mm (0.75 in.) is the measurement the vehicle was manufactured with.
22.
Using pliers, carefully crimp mounting bracket flanges at location (A) until measurement is 17 mm (0.67 in.).
23.
Repeat above steps for left mounting bracket of passenger inflator module.
IMPORTANT:
Passenger inflator module wiring harness should route toward right side of vehicle.
24.
Insert passenger inflator module through I/P opening with vinyl edge facing up and harness toward right side of vehicle.