LW2 V6-3.0L VIN R (2000)
3.
Remove shroud fasteners and remove steering column upper and lower shroud panels.
4.
Insert key into ignition lock cylinder and rotate to RUN position.
^
If ignition lock cylinder can be rotated to RUN position, continue to step 30.
^
If ignition lock cylinder cannot be rotated to RUN position, continue with next step.
5.
Using a light hammer and brass drift, tap lightly on the top side of the ignition housing assembly at the location indicated in the illustration, while
trying to turn the ignition key.
^
If the ignition key turns, proceed to step 30.
^
If the ignition key does not turn replace the ignition module/passlock sensor by continuing with next step.
IMPORTANT:
If ignition module/passlock sensor is replaced Passlock relearn procedure must be performed.
6.
Disable SIR system. Refer to "Disabling Frontal Inflators" procedure in the 2000/2001 S-Series Body Electrical Volume II Service Manual.
