LW2 V6-3.0L VIN R (2000)
3. While holding hub driver with a wrench, tighten hub driver screw to extract hub.
4. If inner race of bearing is pulled out with hub in previous step, remove race from hub using part numbers:
-
8 - Inner race puller
-
9 - Two bridge retainer plates
-
10 - Two bolts
-
11 - Two flat washers
5. Inspect hub at bearing location for pitting, scoring, wear, or corrosion. Replace if necessary.
6. Remove steering knuckle from vice.
7. Remove bridge retainer and bridge.
8. Remove bearing retainer snap ring.
