LW2 V6-3.0L VIN R (2000)
NOTICE: Failure to lubricate the cooler line seals with DEXRON(R) III (P/N 21019228) automatic transaxle fluid before installing the cooler line
assembly into the seals may cause damage to the seals.
1. Place a new transaxle cooler line seal in the case bore.
2. Install the J41239-1 on the transaxle case at the cooler line bracket bolt hole.
3. Press new transaxle cooler line seal in by tightening the seal pressing bolt on the tool until the seal bottoms out in the case bore.
4. Install transaxle oil cooler line assembly to transaxle.
Torque: 8 Nm(71 inch lbs.)
5. Start engine and check for leaks.
6. Check for proper fluid level using the "Transaxle Fluid Level Checking Procedure".
