LW2 V6-3.0L VIN R (2000)
5. Remove TFP switch assembly bolts, and remove switch assembly from control valve body. The seven TFP switch O-rings are reusable if not
damaged, and should remain with pressure switch assembly.
6. Remove remaining control valve body bolts, and remove control valve body assembly.
7. Remove and discard valve body-to-spacer plate gasket.
8. Remove spacer plate support bolts, and remove spacer plate support.
NOTICE: Check balls may fall out of channel plate assembly. Retain check balls with petroleum jelly.
9. Remove spacer plate with spacer plate filter attached.
10. Remove and discard spacer plate-to-channel plate gasket.
INSTALLATION
