LW200 L4-2.2L VIN F (2003)
5. Remove drum/rotor retaining screw.
6. Remove drum/rotor.
7. Remove hub-to-rear axle control arm attachment nuts. Discard nuts.
8. Remove hub/bearing assembly.
INSTALLATION
NOTICE: New nuts must be used as torque retention of old nuts may not be sufficient.
1. Install hub and brake shield to rear axle control arm with new nuts.
Torque:
Rear Hub Assembly-to-Knuckle Nuts: 50 Nm (37 ft. lbs.) + 30° to 45°
2. Install brake rotor/drum and tighten retaining screw.
Torque:
Brake Drum Retaining Fastener: 4 Nm (35 inch lbs.)
3. On vehicles equipped with rear disc brakes, perform the following steps:
