LW200 L4-2.2L VIN F (2003)
2. Insert air bag guide pins in I/P brace slots and rotate round edge upward to align bolt holes.
3. Install fasteners securing air bag to I/P support beam.
Torque:
Passenger Inflator Module (Air Bag) Bolts: 10 N.m (89 in-lbs)
4. Connect yellow two-way connector to the vehicle wiring harness.
5. Install glove compartment.
6. Enable the SIR system. Refer to Air Bag(s) Arming and Disarming.
7. Turn ignition On and verify AIR BAG telltale operates properly.
Curtain Inflator Modules (Air Bag) (If Equipped) - Sedan
CAUTION: SIR SYSTEM SHOULD BE DISABLED BEFORE REMOVAL OF INFLATOR. THE INFLATOR MUST BE DISPOSED OF
PROPERLY. ALL INTERIOR GARNISH MOLDING SNAP-IN CLIPS MUST BE REPLACED WHEN TRIM IS REMOVED FROM THE
VEHICLE. TWISTING OF THE INFLATOR MUST NOT BE ALLOWED.
REMOVAL
1. Disable the SIR system. Refer to Air Bag(s) Arming and Disarming.
2. Remove headliner and garnish moldings from vehicle.
IMPORTANT: Spaceframe Clips and plastic guides must be removed from structure. Spaceframe clips are designed for one use only. The new
