LW200 L4-2.2L VIN F (2003)
Notice:
Ensure the belt is not twisted by buckling the center and outboard seating positions after the seat back assembly and seat cushion have been
installed. Push and pull on the seat belt system to ensure it is secure.
Important:
DO NOT use Threadlocker [horbar] Loctite 242(R) on 11.11 mm (7/16 in) seat belt bolt.
4.
Install buckle/latch assembly and the 11.11 mm (7/16 in) seat belt bolt removed in step 3.A.
Tighten
Tighten seat belt bolt to 42 +/- 6 Nm (31 lb-ft +/- [53 in-lbs]).
5.
Install passenger's side rear folding seat back.
^
Guide seat back assembly onto center pivot pin.
A.
Align outer pivot pin with the lead in ramp on the "Easyload" bracket.
B.
Push downward on the seat back to engage "Easyload" bracket.
C.
Raise seat back and secure seat back latch.
6.
Install rear seat cushion.
^
Position rear seat cushion over rear seat floor area.
A.
Route rear seat belts through cushion openings.
B.
Slide rear seat cushion frame into rear attachment brackets.
C.
Push downward on rear seat cushion forward retainers to lock rear seat cushion to floor brackets.
