LW200 L4-2.2L VIN F (2003)
8. Install steering gear-to-frame using new bolts and nuts and tighten using Torque Angle Gauge SA9140E (or equivalent).
^
Steering Gear-to-Frame: 45 Nm (35 ft. lbs.) + 90°
9. Vehicles equipped with an L61 engine and automatic transaxle, install steering gear heat shield.
^
Steering Gear Heat Shield-to-Frame: 4 Nm (35 inch lbs.)
NOTICE: Hold ball stud from turning when tightening nut. The rubber boot can become torn and damaged if the ball stud turns.
10. Using new nuts, install stabilizer bar link-to-strut assembly.
^
Stabilizer Bar Link-to-Strut: 65 Nm (48 ft. lbs.)
11. Inspect rubber boots for damage and replace if damaged.
12. Install rear transaxle mount.
13. Install two rear transaxle mount to frame bolts.
^
Rear Transaxle Mount-to-Frame Bolts: 60 Nm (44 ft. lbs.)